中文 | English
Home > News > Preparation of the motor before installation
Preparation of the motor before installation
Source:    Nuthor:    send time:2016/3/12 17:37:54
Preparation of the motor before installation

 

 

1, when unpacking the case should be carefully clear the dust on the motor and drive parts of the rust layer, at the same time pay attention to small to damage the sealing of the combination.

 

2, check whether the motor nameplate data meets the requirements, and should pay special attention to the production date, carefully check the motor without deformation or damage in transit, fasteners is

 

No loose or fall off, and turning motor rotation is flexible. Storage time more than a year, such as motor should be carefully check glaze bearing and the bearing of rustily, grease lubrication

 

Rolling bearing grease should be changed.

 

3, check the motor installed actual shape size and random shape, it fits the figure with the host whether conform to, whether the spare parts is complete.

 

4, need to get rid of wound rotor motor conductive slip ring (collector ring) on the plastic film cover, and check the carbon brush device on the slip ring and the slip ring and carbon brush on the conductive lines

 

Whether the short circuit and loose, and clear out the anti-rust oil on the conductive slip ring, avoid sparking when the motor running.

 

5 before installation, the installation personnel must be familiar with factory supply by the random technical documents, such as product specifications, packing list, random figure shape and other technical documents.

 

6, check and adjust the height and flatness, check the location of the holes of anchor bolts and size.

 

7, should be corrected before installation capacity of lifting equipment, will be enough for most pieces of lifting, and lifting method should also be taken into consideration in advance.

 

8, before installation should fully consider the motor installation sequence and during the installation process, each stage of the tools, measuring tool and auxiliary materials, etc.

Same Article
New Article
Home | About | Product | News | Case | Knowledge | Feedback | Contact
Shenzhen JiXin Micro Motor Co,. LTD CopyRight Icp:Guangdong icp45465
Tel: 13826521928 Fax: 0086755-29502645 E-Mail:13826521928@163.com
Address:Office: Room 7L, Floor7, Ruijun Building, Shajing center Rd, Baoan district of ShenZhen Support:Baiuoo Company