中文 | English
Home > News > The maintenance methods of the machine
The maintenance methods of the machine
Source:    Nuthor:    send time:2016/3/12 17:33:59

 

 

Professional motor maintenance center maintenance process: clean stator - replace carbon brush or other components - vacuum pressure varnished F - drying - school of dynamic balance.

 

1, using the environment often should keep dry, motor surface should be clean, the air inlet should not be affected by dust, fiber, etc.

 

2, when the motor thermal protection continuous action occurs, should find out the fault from motor overload or protection setting value is too low, after eliminating fault, may

 

In operation.

 

3, should guarantee the motor in the process of running a good lubrication. General motor running 5000 hours, or should complement or replace grease, found in the operation of the shaft

 

Bearing overheating or lubrication metamorphism, hydraulic in grease in a timely manner. Replacing grease, should clean up the old oil, and gasoline wash oil bearing and the bearing cover, however

 

Will ZL - 3 lithium base grease filling after bearing the cavity between the inner and outer circle 1/2 (of 2) and two-thirds (4, 6, 8).

 

4, when the bearing's life at the end, the vibration and noise will significantly increase the motor running, check the bearing radial clearance of the following values, which should be replaced.

 

5, remove the motor, or from the shaft extension end not stretched out side the rotor can be. If there is no need to remove the fan, or from the axis stretch out side the rotor is more convenient,

 

Drawn from the stator rotor, should prevent damage stator windings or insulation.

 

6, replacing winding must take note of the original winding form, size and number of turns, wire gauge, etc., when the data lost, should be to the factory, change the original set

 

Winding, often make the motor or a few performance deterioration, even not be able to use.

Same Article
New Article
Home | About | Product | News | Case | Knowledge | Feedback | Contact
Shenzhen JiXin Micro Motor Co,. LTD CopyRight Icp:Guangdong icp45465
Tel: 13826521928 Fax: 0086755-29502645 E-Mail:13826521928@163.com
Address:Office: Room 7L, Floor7, Ruijun Building, Shajing center Rd, Baoan district of ShenZhen Support:Baiuoo Company